Air conditioning is all about air flow. We are closing out the week with flex and duct board work.

Duct Board Prep

It’s a hot day so one must be careful not to scratch after cutting duct board… as a few participants learned the hard way. Not to worry, a little practice will get you where you need to be.

During our intensive six-week HVAC Workshop program, be prepared to LEARN by DOING! Looking forward to hearing from you soon as enrollment is close to capacity (maximum of ten) and is happening NOW for the October session.

Danny
407-878-0474
2^nd Chance University
HVAC Technical Academy
Sanford, Florida
Email: info@HVATA.com

Between system swaps, preventive maintenances, and troubleshooting, yesterday was a day of relaxing as we worked through the process to pull and clean an evaporator coil.

Evaporator Coil Pull and Clean

Never just another day at HVAC Technical Academy. With this said, tomorrow we will be designing and installing duct board as our air handlers need a return. Check it out tomorrow!

During our intensive six-week HVAC Workshop program, be prepared to LEARN by DOING! Looking forward to hearing from you soon as enrollment is happening NOW for the October session.

Danny
407-878-0474
2^nd Chance University
HVAC Technical Academy
Sanford, Florida
Email: info@HVATA.com

With two successful system swaps yesterday, today we will work as a team while performing preventive maintenance.

HVACTA Team in PM

Though today we work side by side with fellow participants, soon each will be handling all preventive maintenance duties on their own. Good thing each participant has a new digital Fieldpiece gauge set.

During our intensive six-week HVAC Workshop program, be prepared to LEARN by DOING! Looking forward to hearing from you soon as enrollment is happening NOW for the October session.

Danny
407-878-0474
2^nd Chance University
HVAC Technical Academy
Sanford, Florida
Email: info@HVATA.com

Sometimes there is nothing like pizza and HVAC to make learning the total package… today all shared the experience.

Slicing and Learning

After a quick pizza break, all headed outside to perfect brazing skills, package unit PMs, and getting to know their Fieldpiece digital gauges (theirs to use, theirs to keep).

407-878-0474
HVAC Technical Academy
Sanford, Florida
Email: info@HVACTA.com